Dayton-audio Waveguides Manuel d'utilisateur télécharger pdf

Contents of hardware package:

2 large hex bolts

2 large split-ring lockwashers

2 large hex nuts

RPH-16 & RPH-20 Public Address Horns

Assembly Instructions

Step one:

Insert one large hex bolt through one inner mounting

boss, and position on one of the two yoke mounting

holes on the inside of the horn bell. The inner mounting

boss has a hex-shaped indentation for the bolt head

to rest in. Be sure to place the boss so that the arrow

is pointing toward the mouth or large opening of the

horn. You may ﬁnd it helpful to put a piece of tape over

the bolt head and boss to hold them in position while

repeating the procedure on the other side.

Step two:

With both inner bosses and hex bolts in place, posi-

tion one outside mounting boss on a protruding hex

bolt, again taking care to align the boss with the arrows

pointing to the front of the horn. Hold the inner boss

and bolt with one hand, and place one rubber washer

over the boss.

Step three:

While still holding the hardware from the inside, slip one

end of the U-shaped mounting bracket over the bolt,

capturing the rubber washer. Place one ﬂat washer, one

split ring lockwasher, and one hex nut over the bolt and

thread loosely to hold in place

Step four:

Gently spread the mounting bracket to attach to the

opposite mounting boss, ensuring that the bolt passes

through, and that a second rubber washer is captured

between the bracket and the mounting boss. Place a

ﬂat washer, a lockwasher, and a hex nut on the bolt and

fasten ﬁnger-tight.

Step ﬁve:

Align the three threaded mounting holes on the re-en-

trant tube with the holes on the back or small end of the

main horn assembly. Start a small bolt and washer into

each hole, and then tighten with a wrench.

Step six:

Mount the compression driver of your choice. Tighten

the two large bolts on the mounting bracket, taking care

to not overtighten them.

2 large ﬂat washers

2 black rubber ﬂat washers

2 plastic inner mounting bosses

2 plastic outer mounting bosses

3 small hex screws

3 small ﬂat washers

2008

Assembly Instructions 1

Résumé du contenu

Page 1 - Assembly Instructions

Contents of hardware package:2 large hex bolts2 large split-ring lockwashers2 large hex nutsRPH-16 & RPH-20 Public Address HornsAssembly Instructi

Commentaires sur ces manuels

Pas de commentaire

Dayton-audio Waveguides Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Acoustique Dayton-audio Waveguides. Dayton Audio Waveguides User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Acoustique Dayton-audio Waveguides